Breitbandfernsehantenne mit Dipolen verschiedener Länge und Phasenleitung
Breitbandfernsehantennen bestehen meist aus Dipolen verschiedener Länge, die auf
Frequenzen etwa an den Bandgrenzen abgestimmt und durch eine Phasenleitung verbunden
sind. Da die Phasenleitung länger ist als der Abstand der Dipole und unmittelbar
zwischen die Dipolanschlüsse eingefügt werden muß, wird sie gewöhnlich spulenförmig
aufgewickelt und mit einem eigenen Gehäuse oder einer Umhüllung geschützt, so daß
ein zusätzlicher Aufwand für den @inbau notwendig wird und ein
räumlich
verhältnismäßig großes Gebilde entsteht.Broadband television antenna with dipoles of various lengths and phase line
Broadband television antennas usually consist of dipoles of different lengths, which on
Frequencies matched around the band limits and connected by a phase line
are. Because the phase line is longer than the distance between the dipoles and immediately
must be inserted between the dipole terminals, it usually becomes coiled
wound up and protected with its own housing or casing so that
an additional effort for the @inbau is necessary and a
spatial
relatively large structure emerges.
Durch die Neuerung soll die Aufgabe gelöst werden, die Phasenleitung
auf kleinerem Raum unterzubringen und gleichzeitig gegen Witterungseinflüsse geschützt
einzubauen, ohne daß zusätzliche Bauteile erforderlich werden. Dies wird gemäß der
Neuerung dadurch erreicht, daß die Phasenleitung in Form einer Spule sehr kleiner
Abmessungen ausgebildet und in einem geschlossenen Hohlraum einer Anschlußgarnitur
für die Antennenleitung an den Anschlußstellen eines der Dipole untergebracht wird.
Eine solche Anschlußgarnitur ist ohnehin meist bei Breitbandantennen bereits vorhanden.
Gemäß einem weiteren Gedanken der Neuerung werden zweckmäßig die Anschlußenden des
anderen Dipols zu einer Paralleldrahtleitung umgebogen und in'die AL schlußgarnitur
am anderen Dipol, welche die Spule der Phasenleitung aufnimmt, eingeführt. The aim of the innovation is to solve the problem, the phase line
Can be accommodated in a smaller space and at the same time protected against the effects of the weather
can be installed without the need for additional components. This is done according to the
Innovation achieved in that the phase line in the form of a coil is very small
Dimensions formed and in a closed cavity of a connection fitting
for the antenna line is housed at the connection points of one of the dipoles.
Such a connection set is usually already available in broadband antennas anyway.
According to a further idea of the innovation, the connecting ends of the
other dipole bent over to a parallel wire line and in'die AL end fitting
at the other dipole, which receives the coil of the phase line.
Die Neuerung und weitere Einzelheiten sind anhand von Zeichnungen
in einem Ausführungsbeispiel näher erläutert, und zwar zeigt Fig. 1 eine aus zwei
Dipolen bestehende Breitbandantenne-gemäß der Neuerung in perspektivischer Darstellung
- und Fig. 2 eine Ausführungsform der zu einer kleinen Spule aufgewickelten Phasenleitung. The innovation and further details are based on drawings
explained in more detail in an exemplary embodiment, namely FIG. 1 shows one of two
Dipoles existing broadband antenna - according to the innovation in a perspective view
and FIG. 2 shows an embodiment of the phase line wound into a small coil.
Ein langer Faltdipol F 1 und ein kurzer l'altdipol F2 sind in bekannter
Weise in bestimmtem Abstand an einem Tragrohr T
befestigt. Beide
Dipole sind über eine Phasenleitung zusammen-. zuschalten und mit einer Antennenableitung
L zu verbinden. A long folded dipole F 1 and a short folded dipole F2 are known
Way at a certain distance on a support tube T.
attached. Both
Dipoles are connected via a phase line. switch on and with an antenna lead
L to connect.
An den Anschlüssen des Dipols F. ist hierfür eine Anschluß-
garnitur A aus Isolierstoffe wie Kunststoff oder Preßstoff
arn L
angebracht, in die die Leitung L hineinführt. Die Garnitur kann gleichzeitig auch
zur Befestigung des Dipols am Träger T ausgebildet sein, wobei für die Dipolbefestigung
in bekannter leise Flügelschrauben S benutzt werden können. Die Phasenleitung P
ist als Spule auf einen Spulenkörper K aufgewickelt und besitzt so kleine Abmessungen,
daß sie innerhalb der Anschlußgarnitur A mit untergebracht werden kann. Beispielsweise
soll die betreffende Spule einen Durchmesser von
etwa 5 bis 10 mm und eine Länge von etwa 20 bis 30 mm auf-
weisen. Dabei wird vorteilhaft für die Phasenleitung normaler dünner Spulendraht
benutzt und es werden zwei solcher Drähte parallel auf den Körper K aufgewickelt.
Die Anschlußenden E des anderen Dipols F2 sind zu einer Paralleldrahtleitung'umgebogen,
in die Anschlußgarnitur A eingeführt und dort mit der spulenförmigen Phasenleitung
P verbunden, deren anderes Ende an den Dipol F1 angeschlossen ist sie gehen dabei
mit in die Phasenleitung ein. Auf diese Weise ist ein Antennengebilde geschaffen,
welches für die Phasenleitung keinen zusätzlichen räumlichen Aufwand benötigt.'Am
Tragrohr
T können in bekannter Weise weitere Antennenelemente, wie Di-
rektoren und Reflektoren, befestigt werden.
2 Figl cen
2Schutzansprüche
At the connections of the dipole F. there is a connection set A made of insulating materials such as plastic or molded material
arn L
attached, into which the line L leads. At the same time, the set can also be designed for fastening the dipole to the support T, it being possible to use quiet wing screws S in the known manner for fastening the dipole. The phase line P is wound as a coil on a bobbin K and has such small dimensions that it can be accommodated within the connection set A with. For example, the coil in question should have a diameter of about 5 to 10 mm and a length of about 20 to 30 mm
point. In this case, normal thin coil wire is advantageously used for the phase line and two such wires are wound onto the body K in parallel. The connection ends E of the other dipole F2 are bent over to form a parallel wire line, inserted into the connection fitting A and there connected to the coil-shaped phase line P, the other end of which is connected to the dipole F1, and they enter into the phase line. In this way, an antenna structure is created that does not require any additional space for the phase line T can be further antenna elements in a known manner, such as di-
rectors and reflectors.
2 Figl cen
2 Protection claims