Claims (1)
Способ производства электроэнергии, заключающийся в том, что используют деривационную гидроэлектростанцию, состоящую из одного гидроагрегата, который стационарно устанавливают под водой на дне реки, отличающийся тем, что входной патрубок водонаправляющего аппарата гидротурбины, имеющий заливную горловину с герметичной крышкой, герметично соединяют с входным цельным трубопроводом, имеющим заслонку с возможностью полного перекрытия потока воды через трубопровод, а выходной патрубок отводящей камеры гидротурбины - с выходным цельным трубопроводом, также имеющим заслонку с возможностью полного перекрытия потока воды через трубопровод, при том, что трубопроводы стационарно не закрепляют, но располагают таким образом, чтобы открытый конец начала входного трубопровода находился в воде реки, где расположен гидроагрегат, с которым он соединен, а открытый конец выходного трубопровода - в воде этой же реки, при условии, что водная поверхность реки в этом месте ниже уровня водной поверхности реки в месте нахождения начала входного трубопровода; перед началом работы закрывают заслонки трубопроводов, под давлением внешнего источника воды заполняют систему водой через заливную горловину, после чего заливную горловину герметично закрывают и открывают заслонки трубопроводов.A method of generating electricity, which consists in the fact that a derivative hydroelectric power station is used, consisting of one hydroelectric unit, which is permanently installed under water at the bottom of the river, characterized in that the inlet pipe of the water guide apparatus of the hydraulic turbine, which has a filler neck with a sealed cover, is hermetically connected to the inlet one-piece pipeline having a damper with the ability to completely block the flow of water through the pipeline, and the outlet pipe of the outlet chamber of the hydraulic turbine - with an outlet one-piece pipeline, also having a damper with the ability to completely block the flow of water through the pipeline, while the pipelines are not permanently fixed, but positioned in this way so that the open end of the beginning of the inlet pipeline is in the water of the river where the hydraulic unit with which it is connected is located, and the open end of the outlet pipeline is in the water of the same river, provided that the water surface of the river in this place is below the level of the water surface of the river at the location of the beginning of the inlet pipeline; before starting work, the pipeline valves are closed, under the pressure of an external water source, the system is filled with water through the filler neck, after which the filler neck is hermetically closed and the pipeline dampers are opened.