Claims (1)
RIVENDICAZIONI (1)
3.404) Ogni autorotante con l'uso di due leve di 1° tipo,una con denti o ganci contro la ruota mediana e corda che dalla_ punta del braccio lungo dell'altra,angolata e fulcrata al cent tira dopo l'appoggio sulla r.mediana il raggio dell'anello den tato,la cui reazione con raggio obliquo è bloccata dal bracciq corto di detta leva angolata;e raggi di trascinamento delle du ruote concentriche(eventuali):bastaniio anche i ganci.
3.405)Come sopra al n.3.404 e dal n.0001 al n.3.405,che usa due coppie di leve con appoggi e freni reciproci alterni,ester ci,e raggiobliqui(anche)—volendo-fino alla parte eccenbtrica d la ruota meggaiore.
3.406)Come sopra al n.3.405 ogni autorrotante tra due ruote concentriche,delle quali la mediana per l’appoggio del tirante che sul braccio lungo interrompe l'altra spinta reattiva oppo* sta sul cerchione maggiore col biciclo e asta(con o s.peso). 3.407)Come sopra dal n.l al 3.407,che unisce le due ruote con raggio dalla mediana spinta da raggi del primo biciclo dal qual parte il tirante(con o senza peso) da raggio di anello,e e uno dei due lati del quadrangolare,tirante che si appoggia sull'al tro biciclo pure con due raggi—lato in funzione finale antireat tiva contro il biciclo inaiale o anello libero,sia dall'esterno che con ganascia(cfr.fig.)interna tra i due anelli.
3.408) Autorotante unico fatto con due cerchi concentrici in appoggio reciproco delle Azioni capaci di interrompere e utiliz zare la reazione(le reazioni A—A1)in funzione attiva sul cer chio grande,che tiene ganci dei tiranti,distaccati più omen tramite l1avvolgimento dal cerchio mediano,con o senza uno o due pesi a metà del tirante ( dentro ) e fuori il cerchio me diano sia uno che in coppia.
3.409)Coppia di tiranti e di aste col ritorno sul biciclo dell'altra rispetto,dalla quale parte l'inizio del tirante,o tiranti in coppia tra due ruote e aste angolate leve di Ie e alla fine del capìo di 11° tipo,o comunque,o diffem za raggi e/o differenza bracci,di leve fulcfcate su ruota mediana,e res come sopra al n.3.407.
3.410) Doppi appoggi di tiranti in coppia dal braccio lungo ( ma troppo corto ripspetto a quello corto,ma più lungo)con doppio appoggio,uno su biciclo,per equilibrare i bracci(pesi sui...) e quindi la doppia pressione eccentrica dei due fulcr -sul cerchione della ruota unica,con o senza raggi obliqui con tro detto braccio troppo lungo.
3.411) Come sopra al n.3.407 e seguenti ogni autorotante a trazione doppia eccentrica,per cui l'arco del cerchione tra i due fulcri assorbe la prima reazione(A-R)del tirante,che affe ra coi due capi il braccio lungo di leva che col braccio cort trascina la ruota mediana e il cerchione(con o s.raggi di tra 3.412)Come sopra la n.3.411 ma coi bracci lunghi fino all*
RIVENDICAZIONI 13)
3stemo(volendo,e con p senza peso),e leve/leva di I°....tipo...con= Tro ruota mediana e .(con o senza raggi)cerchione della r.maggl
3.413) Doppio triciclo al centro e sul cerchione della ruota (unica o maggiore della concentrica)con tirante sui due raggi dell'smallo maggiore,esterno,dal centro a quello in circonf.za dal quale il raggio lungo in trazione(di corda eccentrica) o in spinta dal cerchione.ruota grande,la cui reazione è uniforme,pe cui la formula della forza è F+=A R;e altr tirante dall'anell mediano,il cui raggio dal cerchione spinge il raggio lungo del= l'anello esterno(predetto),la cui Reazione R' è frenata e quasi annullata dal raggio obliquo lungo,proveniente dal detto anello mediano centrale, in funzione antireattiva:sdì'.
3.414)Come sopra dal n.0001 sa n.3.413 e a questo che crea una RUOTA MOTORE fatto con due ruote concentriche e una doppia leva bicldo(o altra fig.geom.)su susta poggiata sopra la ruota medisma,con o senza gancio,con tirante(con o senza peso)dal ;braccio corto a quello lungo che attiva la leva in pressione j ;del cerchione della r.maggiore e sinché in trazione con corda; ;tramite tra bicicli che distanziano da un lato il tirante.
3.415) Come sopra al n.3.414 anche questo fa un moto're con ,due ruote concentriche( o ruota e anello di asse centrale)sul I quale si appoggisuio(fuori e dentro)! tre bicicli che distanzi ano da un lato il tirante,che con asta leva spinge la ruiota |
maggiore,con forza F= 2 3,o braccio lungo di leva di Ietipo;
RIVENDICAZIONI (4)
3.416) Come sopra al n.3.414(che li include tutti)e come al presente che vuol fare un autortante con due bicicli laterali {oaltre figg.geomm.)appesi con corda al cerchione della ruota maggiore, di cui(quello di destra nell'ipotesi)ha la spinta Ati tiva con ganci contro il cerchione{o gancio e ponte di sezioni) e la cui Reazione è bloccata da una corda in funzione aR(antil Reattiva)proveniente dalla ruota(aneÌlo grande)mediana e attac cata all'altro anello,e proveniente dal biciclo di sinistra,at= tivato da tirante tra raggio di anello(interno nell'ipotesi) e raggio della ruota med.,che ha la sua Reazione bloccata dal raggio dell'altro anello,con tirante(e/o peso- eventuale)
tra il suo raggio e quello del primo biciclo(destra),con o sen= za Centrifugazione ( C.) e Newton ( N. ),per cui la Forza (F = = A),dove A,indica Azione o spinta iniziale,ben appoggiata da doppia antiReazione,quindi libera di far girare la RUOTA DUE,la cui spinta,specie se aiutata da peso,che raddoppia(quasi)ad ogni giro,è illimitata.Sia con uno o due tiranti,sia con peso senza tirante,tiranti;sia solo tirante,soli tiranti.Con senza raggi o corda di trascinamento(sincronia)tra le due ruote. 3.417) Biciclo in trazione eccentrica della ruota maggiore con
raggio antireattivo dall'altra mediana,dalla quale anche il ti= rante dal raggio obliquo,con ο senza raggi di trascinamento. 3.418 ) - 3.419) Cerne sopra dal n.QOOl al n.2.417 e a questo sistema autorotante con leva di 1° tipo sulla ruota mediana e fallai)braccio corto con gancio ( corda in trazione )in spinta della ruota maggiore,con o senza ganci(raggi,corda)di trasc.to. CLAIMS (1)
3.404) Each self-rotating with the use of two 1st type levers, one with teeth or hooks against the median wheel and a rope that from the tip of the long arm of the other, angled and pivoted to the cent, pulls after resting on the r. median the radius of the tooth ring, whose reaction with an oblique radius is blocked by the short arm of said angled lever; and the dragging radii of the two concentric wheels (if any): hooks too.
3.405) As above at n.3.404 and from n.0001 to n.3.405, which uses two pairs of levers with reciprocal supports and brakes, alternating, external, and radius (also) - wanting-up to the eccentric part of the largest wheel .
3.406) As above in n.3.405 each self-rotating between two concentric wheels, of which the median for the support of the tie rod which on the long arm interrupts the other reactive opposite thrust is on the larger rim with the bicycle and rod (with or s. weight). 3.407) As above from n.l to 3.407, which joins the two wheels with a radius from the median pushed by spokes of the first bicycle from which the tie rod (with or without weight) from the ring spoke starts, and and one of the two sides of the quadrangular, tie that it rests on the other bicycle also with two spokes - side in a final antireactive function against the initial bicycle or free ring, both from the outside and with an internal jaw (see figure) between the two rings.
3.408) Single self-rotating made with two concentric circles in mutual support of the Actions capable of interrupting and using the reaction (reactions A - A1) in an active function on the large circle, which holds the hooks of the tie rods, detached more men by winding the circle median, with or without one or two weights in the middle of the tie rod (inside) and outside the circle give me either one or in pairs.
3.409) Pair of tie rods and rods with the return on the bicycle of the other respect, from which the start of the tie rod starts, or tie rods in pairs between two wheels and angled rods Ie levers and at the end of the 11th type section, or in any case, or spoke difference and / or arm difference, of pivoted levers on median wheel, and res as above in n.3.407.
3.410) Double supports of tie rods in pairs with the long arm (but too short compared to the short one, but longer) with double support, one on a bicycle, to balance the arms (weights on ...) and therefore the double eccentric pressure of the two fulcrums on the rim of the single wheel, with or without oblique spokes with said arm too long.
3.411) As above at 3.407 and following, each self-rotating double eccentric traction unit, whereby the arc of the rim between the two fulcrums absorbs the first reaction (A-R) of the tie rod, which grips with the two ends the long lever arm which with the short arm drag the middle wheel and the rim (with or without radii of between 3.412) As above the n.3.411 but with the long arms up to *
CLAIMS 13)
3stemo (if desired, and with p without weight), and levers / I ° lever .... type ... with = Tro middle wheel e. (With or without spokes) rim of the r.maggl
3.413) Double tricycle in the center and on the rim of the wheel (single or larger than the concentric one) with tie rod on the two spokes of the larger, outer shoulder, from the center to the one in the circumference from which the long spoke in traction (of eccentric rope) or in thrust from the rim. large wheel, whose reaction is uniform, for example where the force formula is F + = A R; and the other tie rod from the median ring, whose radius from the rim pushes the long radius of = the outer ring ( predetto), whose Reaction R 'is slowed down and almost canceled by the long oblique radius, coming from said central median ring, in an antireactive function: yes'.
3.414) As above from n.0001 to n.3.413 and to this that creates a MOTOR WHEEL made with two concentric wheels and a double double lever (or other fig.geom.) On a susta resting on the medisma wheel, with or without hook, with tie rod (with or without weight) from the short to the long arm that activates the lever under pressure j of the rim of the major r.and until in traction with the rope; ; through between bicycles that space the tie rod on one side.
3.415) As above in 3.414, this one also makes a moto're with, two concentric wheels (or wheel and central axis ring) on which it rests (outside and inside)! three bicycles that distances the tie rod on one side, which pushes the wheel with a lever rod |
greater, with force F = 2 3, or long lever arm of Ietype;
CLAIMS (4)
3.416) As above at 3.414 (which includes them all) and as in the present that he wants to make a self-supporting with two side bicycles (or other figs. hypothesis) has the Active thrust with hooks against the rim (or hook and bridge of sections) and whose reaction is blocked by a rope in function aR (antil Reactiva) coming from the median wheel (large anel) and attached to the other ring, and coming from the left bicycle, activated by a tie rod between the ring spoke (internal in the hypothesis) and the middle wheel spoke, which has its reaction blocked by the spoke of the other ring, with tie rod (and / or weight - if any)
between its radius and that of the first bicycle (right), with or without Centrifugation (C.) and Newton (N.), so the Force (F = = A), where A, indicates Initial Action or thrust, well supported by double anti-reaction, therefore free to spin WHEEL DUE, whose thrust, especially if aided by weight, which doubles (almost) at every turn, is unlimited. tie rods; both tie rods, tie rods only.With no spokes or drag rope (synchronicity) between the two wheels. 3.417) Bicycle in eccentric traction of the larger wheel with
antireactive beam from the other median, from which also the ti = rant from the oblique beam, with ο without trailing rays. 3.418) - 3.419) Cerne above from n.QOOl to n.2.417 and to this self-rotating system with 1st type lever on the middle wheel and fallai) short arm with hook (rope in traction) pushing the larger wheel, with or without hooks (rays, chord) of transc.to.