Claims (1)
RIVENDICAZIONE(1)
3.232)Come spra dal n.0001 al n.3.231 e a questo che vuole un motore RUOTA.tramite tirante eccentrico dal cerchione ad un' asta angolata piantata su biciclo appoggiato dentro la cinghia che abbraccia anche tutta la circonferenza della ruota.sia dal medesimo lato del tirante che dall'altro,sia con o senza peso, con prolungamento del tirante lineare,a appoggiato,e/o incro ciato sull'anello centrale;e appoggio del tirante su tale anello.
3.233) Come sopra al n.3.232) e al successivo numero uguale 3.234)che prevede la coppia del tirante eccentrico e i due bici= eli dentro la cinghia(corda)del cerchione dell'unica ruota,el' altro capo sulla punta,e a fianco dell'anello per sostegno, dell' asta angolata ad angolo retto o comunque;anche nell'ipotesi dei due bicicli dentro la circonferenza della ruota,o anche dentro una corda(cinghia)più piccola,attorno all'anello centrale;con o senza peso,con o senza tirante(prolungamento di)incrociato al centro.
3.235 e 3.236)come sopra ai precedenti 3.232,37233,3.234 e a questo che in più ha un eventuale appoggio su tirante o su ru> ota dell'asta reattiva,antireattiva,col biciclo sia fuori che dentro il cerchione.
3.237 e 3.238) con l'indicazione della Centrifugazione del pei so( C ),e dell'eventuale(perpendico lare)uso di Newton -PENDOLO.
3.239}Due ruote concentriche,una per la trazione eccentrica attiva e l'altra per la reattiva su gancio,asta angolata e bici ciò interno al cerchione antireattivo.
3.240)Come s.da 1 a questo con. tre leve di I° tipo. due col tirante e/o neso da biciclo per corda centra le in trazione della terza laterale su aste o bicìcli.
RIVENDICAZIONI (2)
3.240 A)Come sopra dal n.0001 al 3.240, questo presenta un sistema complesso autorotante.con tirante centrale da due laterali li su leve di I° tipo o bicicli,da biciclo grande(con o senza peso),o da punti equidistanti della ruota grande ai bicicli o sinbgole leve su rafei—fulcri, " tirante centrale " dalla somma dei due bracci corti,,in trazione di una terna leva — biciclo o su raggio,per cui Forza — A R(Azione Reazione );con o sen za ganci antiscivolo ..agli anelli interni.E ruota o ganci anti(:.
3.241)Come la precedente,ma col tirante non più centrale,ma dalla parte della terza leva o biciclo in funzione di leva di I° tipo,con braccio corto contro(come sopra)1'altro cerchione. diverso da quello della r.mediana sul quale è fulcrato,come en che l'altra leva di I° tipo,che ha il braccio lungo col tirants eccentrico dal cerchione più grande,,e il braccio corto con la detta corta tirante non più centrale,ma laterale.
3.242)Come i precedenti per cui F=A+A',o Forza uguale Azione più Azione seconda,dal tirante laterale ( con o senza peso cen tralizzandolo),che agisce su raggio di anello centrale per far ingranare e spingere i denti di ruota mediana,e la cui reazion9 è bloccata e superata dalla leva angolata di I° tipo,fulcrata sull'anello interno(nell'Ipotesi)di biciclo appeso con corda al cerchione più grande,e l'altra dentato,contro detti ingra. naggi di r.mediana, con la corda dall'anello mediano su raggio 3.243) Leva di II° tipo sui due cerchini,unitl da raggio, e RIVENDICAZIONI(3)
Leva di i° tipo dall'altro lato fulcrata con asta lunga dentro il cerchione più grande,legate(le forze opposte)da.corda.sulla. aunta del braccio corto,mentre il lungo è premuto dal tirante dall'altro lato sull'asta di II° tipo(leva di).
3.244)Come la precendente semplificata al punto che da un la= to dentro il cerchione deIl'unicaruota che il tirante dal cer= chione al braccio lungo della leva di I° tipo,fulcrata su asta lunga dentro il cerchione e il braccio corto contro il medesimo cerchione in modo che due forze si annullino a vicenda.e ne ri= suiti una sola uniforme al moto o comunque per il modo(con o «enza peae,semmai.riposizionando gli appoggi del tirante per= che siano.equidistanti da esso al centro).
3.245)Come la precedente,ma con utilizzo del fulcro,non più lungo dentro il cerchione,ma corto contro illato della r.medl ejna(,che con suo raggio spinge il cerchione più grande.
3.246)Come sopra le 3.240 e 3.240A).anche questa con tirante centrale spinge contro il cerchione gr'ande dal fulcro biciclo sulla ruota m.ll braccio corto,,per unificare la reazione(R)all. Azione (A),donde F=A+R,con o senza raggi di trascinamento 3.247)Come la precedente,ma senza biciclo,ma fulcrata quasi direttamente sul cerchione mediano{r.m.) e raggi di
to o sincronia tra le due ruote concentriche.
3.248)Come sopra dal n.0001 al n.3.248)che gira da solo con due ruote concentriche e due tiranti,di cui uno blocca sul cer=
RIVENDICAZIONI(4)
chione la spinta uguale e contraria di leva angolata di I° tipo 04 7 fulcrata sul biciclo laterale appoggiato ad anello di asse ; centrale,che va contro il cerchione grande,anche con raggio obliquo tirato dal detto tirante eccentrico su esso,,e il brac= ciò lungo della detta asta leva di I° tipo angolata tirato dal secondo tirante che arriva al cerchione mediano,che con suo rag gio,insieme all'altro,spingono il raggio del cerchione più gran de.
3.249)Come sopra al n.3.248 e precedenti fino al n.l,sia in toto che in parte,e misti,e ad assetto variabileCome questo n. con due aste leve,una col braccio lungo molto corto e quello lungo angolato,braccio corto della leva di I) tipo e di II° sul fulcro che diventa girevole,o almeno diventa spinta anti= reattiva contro un anello del biciclo - motore contro la ruo= ta mediana,e quindi con suo raggio contro la ruota grande,moto re spinto dall‘etltra leva col braccio lungo fino all'anello (esnterlo,nell'ipotesi)o raggio contro ruota mediana.
3.250)Di questo autorotante(compresi il precedente e gli al= tri) spinto soprattutto dall'asta antireattiva contro un bici ciò motore con gancio contro il cerchione della ruota grande, portatrice delle ùue spinte provenienti dalla ruota mediana e fatta da un braccio corto di leva interna ad un biciclo motore ai poli,esterni, e dal fulcro di una delle due leve di i° tipo, tiranti sui bracci lunghi con o senza pesi. CLAIM (1)
3.232) As spra from n.0001 to n.3.231 and to this he wants a WHEEL motor by means of an eccentric tie rod from the rim to an angled rod planted on a bicycle resting inside the belt that also embraces the entire circumference of the wheel. Both on the same side of the tie rod and on the other hand, either with or without weight, with extension of the linear tie rod, supported, and / or crossed on the central ring; and support of the tie rod on this ring.
3.233) As above at 3.232) and at the following equal number 3.234) which provides for the torque of the eccentric tie rod and the two bikes = eli inside the belt (rope) of the rim of the single wheel, and the other end on the tip, and alongside of the support ring, of the angled rod at right angles or in any case; even in the hypothesis of two bicycles within the circumference of the wheel, or even within a smaller rope (belt), around the central ring; with or without weight , with or without tie rod (extension of) crossed in the center.
3.235 and 3.236) as above to the previous 3.232.37233.3.234 and to this which in addition has a possible support on the tie rod or on the rod of the reactive, anti-reactive rod, with the bicycle both outside and inside the rim.
3.237 and 3.238) with the indication of the weight Centrifugation (C), and of the possible (perpendicular) use of Newton -PENDULUM.
3.239} Two concentric wheels, one for active eccentric traction and the other for reactive on hook, angled rod and bike, inside the anti-reactive rim.
3.240) As s.da 1 to this with. three I ° type levers. two with the tie rod and / or bicycle link for central rope in traction of the third lateral on rods or bicycles.
CLAIMS (2)
3.240 A) As above from n.0001 to 3.240, this presents a self-rotating complex system with central tie rod from two lateral ones on 1st type levers or bicycles, from large bicycles (with or without weight), or from equidistant points of the large wheel on bicycles or single levers on raphei - fulcrums, "central tie rod" from the sum of the two short arms, in traction of a triad lever - bicycle or spoke, for which Force - A R (Action Reaction); with or without non-slip hooks .. to the inner rings. and rotates or anti (:.
3.241) As the previous one, but with no longer central tie rod, but on the side of the third lever or bicycle as a type I lever, with short arm against (as above) the other rim. different from that of the median on which it is pivoted, as in that the other lever of I ° type, which has a long arm with eccentric tirants from the larger rim, and the short arm with said short tie no longer central , but lateral.
3.242) As the previous ones for which F = A + A ', or Force equal Action plus Second Action, from the lateral tie rod (with or without central weight), which acts on the central ring spoke to engage and push the wheel teeth median, and whose reaction9 is blocked and overcome by the angled lever of type I, pivoted on the inner ring (in the Hypothesis) of the bicycle hanging with a rope from the larger rim, and the other toothed, against said ingra. naggi di r.mediana, with the chord from the median ring on the radius 3.243) 2nd type lever on the two circles, unitl from the radius, and CLAIMS (3)
I ° type lever on the other side, pivoted with long rod inside the larger rim, linked (the opposite forces) by the rope. aunta of the short arm, while the long one is pressed by the tie rod on the other side on the II ° type rod (lever of).
3.244) As the previous one simplified to the point that from one side inside the rim of the single wheel that the tie rod from the rim to the long arm of the 1st type lever, pivoted on a long rod inside the rim and the short arm against the same rim so that two forces cancel each other out and result in a single uniform motion or in any case for the mode (with or without peae, if anything, repositioning the tie rod supports so that they are equidistant from it to the center).
3.245) As the previous one, but with use of the fulcrum, no longer inside the rim, but short against the side of the r.medl ejna (, which with its radius pushes the larger rim.
3.246) As above 3.240 and 3.240A). Also this one with central tie-rod pushes against the large rim from the bicycle fulcrum on the short arm wheel, to unify the reaction (R) all. Action (A), whence F = A + R, with or without driving spokes 3.247) As the previous one, but without bicycle, but pivoted almost directly on the median rim {r.m.) And
to or synchrony between the two concentric wheels.
3.248) As above from n.0001 to n.3.248) which rotates by itself with two concentric wheels and two tie rods, one of which locks on the cer =
CLAIMS (4)
chione the equal and opposite thrust of the 1st type angled lever 04 7 pivoted on the lateral bicycle resting on an axis ring; central, which goes against the large rim, even with an oblique radius pulled by the said eccentric tie rod on it, and the long arm of the said angled I ° type lever rod pulled by the second tie rod which arrives at the median rim, which with its radius, together with the other, push the spoke of the larger rim.
3.249) As above at 3.248 and previous up to number 1, both in whole and in part, and mixed, and with variable structure. with two lever rods, one with a very short long arm and the long angled one, short arm of the I) type and II ° lever on the fulcrum that becomes rotatable, or at least becomes anti-reactive thrust against a ring of the bicycle - motor against the median wheel, and therefore with its radius against the large wheel, motion pushed by the other lever with the long arm up to the ring (esnterlo, in the hypothesis) or spoke against the median wheel.
3.250) Of this self-rotating one (including the previous one and the others) pushed above all by the anti-reactive rod against a motor bike with hook against the rim of the large wheel, bearing the two thrusts coming from the middle wheel and made by a short arm of internal lever of a motor bicycle at the external poles and from the fulcrum of one of the two 1st type levers, tie rods on the long arms with or without weights.