Claims (1)
RIVENDICAZIONI (1)
2.995)Come sopra ai nn.2.993 e 2.994 cerchione aperto con biciclo e/o peso con tirante trasversale dall'anello del biciclo al braccio corto della leva che spinge il labbro superiore corda eccentrica da esso,e pure raggio corrispondente sul mede simo biciclo(medesimo anello del Bic.)
2.996)Come sopra dal n.2.999,94,95 anche questo come il pr? cedente ha il biciclo (e/o peso)sul labbro basso,interno,,ch? preme sul braccio lungo della leva di 1? tipo fulcrata con anello di asse centrale o ruota mediana al centro,cordea e o tirante(e/o peso)laterale dal labbro superiore al braccio ? corto della leva o verticale sul lato della ruota in basso.,e una o due sponde ai lati del biciclo(e/o peso,da uno o da due labbri,solito raggio centrale o due ai lati dellai'arco fisso, biciclo (e/o peso ) al centgro del labbro inferiore o di lato come nel n.2.997,che imita il 2.996,e rafforza la spinta della leva di 1? tipo contro la punta dell'apertura siuperiore.
(2.997) -2.998)Trazione eccentrica sull'asta raggio di r.medi= ana, e .sul.labbro basso dell'apertura per.spingere la leva contro la punta del labbro superiore,e come sopra al.2.993 .
2.999)Come sopra ai precedenti.dal 2.993 in.polfino a questo che ha il tirante eccentrico.dalla parte del raggio.,in traziona delle due punte .con asta dal maggiore.contro il labbro minore e corda da questo al maggiore vicino alle due punte.
3.000)Come sopra al n.2.999 con trazione eccentrica in basso incrociata per tenere il peso stretto nel biciclo (anche senza peso) contro il labbro inferiore, con gancio a destra e corda a sinistra (nell' ipotesi) .
3.001.Come sopra dai nn.seguenti al 2.981 inizio delle aperte fino a questo n.3.001, che rivendica ogni sistema di mo= tore fatto con tirante centrale in partenza da anello di asse o ruota mediana,o dal medesimo anello della mezza ruota,e in arrivo sul semicerchio interno labbro interno)per spingerne l' arco sul braccio lungo della leva di I? tipo,che col braccio corto spinge la parte aperta finale del semicerchio esterno 3.002)Come sopra dal n.0001 a questo n.3.002 che ha la trazi one eccentrica dalla parte del raggio della semiruota fissa per stringere i due capi(ledue punte,terminali)delle due aperture (labbra) e spingerle contro i due raggi eccentrici angolati del la ruota concentrica mediana,e quindi in rotazione simultanea. tirante con o senza peso,e/o eventuale biciclo (con eventuale peso)e tirante incrociato come in fig.3.000,da sopra l'arco del semicerchio interno o labbro inferiore
3.003) Come sopra al n.3.002 questo che evidenzia la assen= za di Reazione(R-R')in quanto la spinta non ? a trazione,ma a
pressione eccentrica dei due semicerchi(interrotti)sui due raggi angolati di anello centrale
da tirante con biciclo sul labbro minore(interno)(e/o maggiore? -esterno) con o senza peso,con corda con o senza tirante,incro ciata sul medesimo o altro anello (ruota mediana)centrale,fino RIVENDICAZIONI (3 )
ai due capi di apertura ( labbra superiore e inferiore).
3.004)Come sopra gli ultimi due e soprattutto gli ultimi 22 (ventidue)con tirante tra labbro (arco)superiore ed esterno,e labbro inferiore(arco)interno,e leva,con o senza peso(o con pe= so con corda con o senza tirante) al centro o a lato,o raggi a lato.
3.0005)Come sopra dal n.0001 al n.3.004 spirale con tirante laterale dall'arco esterno,grande,al raggio,graccio lungo di le va di I? tipo fulcrata al centtro e con doppio risvolto sul brac ci? corto per trazione dell'arco corto della spirale e spinta sul raggio della ruota mediana o anello di asse centrale.con o senza altra spinta sul braccio lungo di tale raggio;e solo que= sta pi? lunga senza quella alla base(braccio corto).
3.000)Come sopra al precedente n.3.008,anche questo 3.006 con tra zione laterale tra la fine dell'arco esterno e l'inizio quasi della leva fulcrata al centro,che con braccio cortoi spinge la punta dell'altro arco spirale,e gancio raggio tra l'arco al= to esterno,e l'esterno di quello interno(arco inferiore,minore) e raggio attaccato o meno (o solo in appoggio)della ruota o anel lo di asse centrale.
3.007)Come sopra al 3.006,con tirante o corda laterale tra i due archi di spirale,e con o senza peso sull'arco minore contro raggio con uno o due attacchi,sull'anello,uno,e si o no sulla spirale;e spinta finale della spirale su tale raggio.
RIVENDICAZIONI (4)
3.008) Come sopra al precedente 3.007 con tirante laterale dall'arco esterno(grande)della spirale alla leva fulcrata alcen tro con appoggio o con anello e braccio corto spinto o meno da eventuale peso e insieme con il braccio corto della leva e del l'arco finale contro il raggio di anello centrale.
3.009)Come sopra dal n.0001 a questo 3.009Con tirante dalla punta esterna della spirale al braccio lungo della leva fulcrata al centro,e fulcro asta da essa all'arco minore della spirale che insieme al braccio corto della leva spingono il raggio luungo dell'anello fulcrato al centro o anello di asse centrale. CLAIMS (1)
2.995) As above 2.993 and 2.994 open rim with bicycle and / or weight with cross tie from the ring of the bicycle to the short arm of the lever that pushes the upper lip of the eccentric cord from it, and also the corresponding radius on the same bicycle ( same ring as the Bic.)
2.996) As above from n. 2,999,94,95 also this as the pr? cedant has the bicycle (and / or weight) on the lower, inner lip ,, ch? presses on the long arm of the lever by 1? fulcrum type with central axis ring or median wheel in the center, cord and or tie rod (and / or weight) from the upper lip to the arm? short of the lever or vertical on the side of the wheel below. / or weight) to the center of the lower lip or to the side as in # 2.997, which imitates 2.996, and strengthens the thrust of the 1st type lever against the tip of the upper opening.
(2.997) -2.998) Eccentric traction on the rod radius of medium = ana, and on the lower lip of the opening to push the lever against the tip of the upper lip, and as above al.2.993.
2.999) As above to the previous ones, from 2.993 in.polfino to this one that has the eccentric tie-rod. On the side of the radius., In traction of the two points. spikes.
3.000) As above in n.2.999 with eccentric traction at the bottom crossed to keep the weight tight in the bike (even without weight) against the lower lip, with hook on the right and rope on the left (in the hypothesis).
3.001 As above from the numbers following the 2.981 start of the openings up to this number 3.001, which claims every motor system made with a central tie rod starting from the axle ring or middle wheel, or from the same ring of the half wheel, and arriving on the inner semicircle inner lip) to push the arc on the long arm of the lever of I? type, which with the short arm pushes the final open part of the outer semicircle 3.002) As above from n.0001 to this n.3.002 which has the eccentric traction on the part of the radius of the fixed semicircle to tighten the two ends (the two tips, terminals ) of the two openings (lips) and push them against the two angled eccentric spokes of the median concentric wheel, and therefore in simultaneous rotation. tie rod with or without weight, and / or possible bicycle (with possible weight) and cross tie rod as in fig. 3000, from above the arch of the inner semicircle or lower lip
3.003) As above at 3.002 this one which highlights the absence of Reaction (R-R ') as the thrust does not? tensile, but a
eccentric pressure of the two (interrupted) semicircles on the two angled spokes of the central ring
from tie rod with bicycle on the lower (internal) (and / or greater? -external) lip with or without weight, with rope with or without tie rod, crossed on the same or other central ring (middle wheel), up to CLAIMS (3)
at the two opening ends (upper and lower lips).
3.004) As above the last two and above all the last 22 (twenty-two) with tie rod between upper and outer lip (arch), and inner lower lip (arch), and lever, with or without weight (or with pe = so with rope with or without tie rod) in the center or on the side, or spokes on the side.
3.0005) As above from n.0001 to n.3.004 spiral with lateral tie from the external arch, large, to the radius, long graccio of le va di I? type with fulcrum in the center and with double flap on the arm there? short for traction of the short arc of the spiral and thrust on the radius of the median wheel or ring of central axis. with or without other thrust on the long arm of this radius; and only this more? long without the one at the base (short arm).
3.000) As above 3.008, also this 3.006 with lateral traction between the end of the external arc and the almost beginning of the lever pivoted in the center, which with a short arm pushes the tip of the other spiral arc, and hook radius between the arc at the outer edge, and the outer arc of the inner one (lower arc, minor) and radius attached or not (or only in support) of the wheel or ring of the central axis.
3.007) As above 3.006, with tie rod or lateral chord between the two spiral arches, and with or without weight on the minor arch against radius with one or two attachments, on the ring, one, and yes or no on the spiral; and final thrust of the spiral on this radius.
CLAIMS (4)
3.008) As above 3.007 with lateral tie rod from the external arc (large) of the spiral to the lever pivoted at the center with support or with ring and short arm pushed or not by any weight and together with the short arm of the lever and the final arc against the central ring radius.
3.009) As above from n.0001 to this 3.009 With tie rod from the outer tip of the spiral to the long arm of the lever pivoted in the center, and rod fulcrum from it to the minor arc of the spiral which together with the short arm of the lever push the long radius of the 'center fulcrum ring or central axis ring.