Beschreibung
der Stansensortimentskluppe mit Reisser.
Daß oben angeführte Gerbt dient hauptsachlich ur Messung und
Kennseichnung von Baumstangen (Sortierung), Das Gerät fordert
und bewerkstelligt somit die in der Forstwirtschaft vorgeschrie-
bene und übliche Vermessung nach der Holsmessaneisong vom l.
lo.
1936.
description the Stans assortment clip with Reisser.
The above tanning is mainly used for measurement and
Identification of tree poles (sorting), the device requests
and thus manages the forestry requirements
bene and customary measurement according to the Holsmessaneisong from l. lo.
1936.
Die Stangensortimentskluppe mit Reisser besteht 1. aus einem Handgriff.
Der Handgriff ist 11 cm lang und besteht im wesentlichen aus einem runden Holzstück.
Im ausgebohrten Innenteil ist die Hauptsprosse des eigentlichen Gerates eingeführt,
dessen Ende bis zieh Zeichnungdurchgeht und dort hinter einer runden Eisenscheibe
plattgenietet ist.The bar assortment clip with tearer 1. consists of one handle.
The handle is 11 cm long and consists essentially of a round piece of wood.
The main rung of the actual device is inserted in the drilled out inner part,
the end of which goes through to the drawing and there behind a round iron disk
is riveted flat.
2. aus den Messprossen. Hier ist der Hauptspross b) und die Seitensprossen
c) - h) zu unterscheiden. Der Hauptspross, aus 8 mm dickem Rundeisen, msist von
Handgriff bis zur
Spitze 3o cm. Die Seitensproasen gehen rechtwinkelig vom
Hauptspross ab und bestehen aus 5 mm dickem Rundeisen,
D18 Seitenaproesen c) und h) sind einmal geknickt. Die
Seitensproseen c, d a » e haben eine länge von 7#5 ms f)
. von 16, 5 ca und g) u. h) von 9 cm. Auf den Sprossen sind
Zahlen eingeschlagen, die die Entfemonß zwischen den je-
weiligen Seitensprossen angeben und den Massen der Homs-
Stangenklacsen entsprechen,
3. aus einem Retisser. Dieser ist an dem Ende der Haoptsprosse befestigt und gleicht
den im Walde gebräuchlichen Reisshaken. Das Material besteht aus hochwertigem Edelstahl.
Der Abweichwinkel von der Hauptsprosse beträgt 55 Grad.
Die Starigensortimentsklappe mit Reisser findet in der
Porstwirtschaft im StangenhauLungsbetrieb Verwendung und
weist gegenüber der bisherigen Form folgende Vorteile auf :
A. unbedingt richtige Sortierung, vor allem auch deshalb,
weil der HolzmessanwBisung entsprechend mit Rinde vermet-
» n wird 9
B. Zeitersparnis durch gleichzeitige Messung und Kennzeich-
nung der Stange in einem Arbeitsgang, sowie durch richti-
ge Binlegung der Sortierung in den Arbeitsverlauft Ein-
spyoBg von Laufwegen, Kreide u. a. Hilfsmitteln oder Ge-
raten.
C Bessong und Kennzeiohnung durch nur ein Gerät, dadurch
elmmellge und b : Lllige
at Xosax ew3rseiOn au : reh nnt * : L2 :
n « bw bg te « w
D. Vielseitige Verwendungsmöglichkeit des Gerätes auch für
den ? rataaBn, <. B. beim Auszeichnen von Sortimentahieben.
2. from the measuring rungs. A distinction must be made here between the main shoot b) and the side shoots c) - h). The main stem, made of 8 mm thick round iron, is from the handle to the Tip 3o cm. The side sprouts go at right angles from the
Main shoot and consist of 5 mm thick round iron,
D18 Side approaches c) and h) are kinked once. the
Side branches c, that »e have a length of 7 # 5 ms f)
. of 16, 5 ca and g) u. h) of 9 cm. Are on the rungs
Numbers that indicate the distance between each
indicate the occasional side rungs and face the masses of
Correspond to bar claws,
3. from a retisser. This is attached to the end of the Haoptsprose and resembles the tear hooks commonly used in the forest. The material consists of high quality stainless steel. The angle of deviation from the main rung is 55 degrees. The Starig product range flap with Reisser can be found in the
Porstwirtschaft in the bar house use and
has the following advantages over the previous form:
A. absolutely correct sorting, especially therefore,
because the wood measuring instruction is appropriately mixed with bark.
»N turns 9
B. Time savings through simultaneous measurement and labeling
the rod in one operation, as well as through correct
integration of sorting into the work process
spyoBg of walking paths, chalk and other aids or tools
guess.
C Bessong and identification by only one device, thereby
elmmellge and b: lllige
at Xosax ew3rseiOn au: reh nnt *: L2:
n «bw bg te« w
D. Versatile use of the device also for
the ? rataaBn, <. B. when marking product ranges.