Very Tiny Wars

I've been mulling over 3mm terrain for the past ten days or so and my thoughts have turned to how to model forests. Earlier this year, on TheMiniaturesPage.com, one of my favorite posters gave this tutorial. 

When looking down onto his finished product, it certainly looks good:

Basically, foilage clusters embedded into latex glue, which he then cured in a warm oven. Great idea! But it's relatively two dimensional, i.e. it has very little height to it. Certainly in comparison to a 1/600 scale tank, it's not nearly tall enough to represent appropriately scaled trees. It looks more like an area of rather large bushes. Another problem for me is that when a unit is "inside" the forest, I would either have to sit it on top of the "trees" or drape the entire latex forest over the unit. Both options seem quite clumsy and aesthetically unpleasant to me.

So, what I want is a forest that has height to it, can be neatly set over the top of my ground units, and looks at least reasonably like trees. Hmmm....

Here's what I've come up with. I cut a small randomly shaped piece of sheet styrene that was thick enough to be quite rigid. I clipped the tips off of some thin gauge 3/4" brads (very small nails):

I then drilled holes through the styrene at regular intervals all the way around the edge and I superglued the clipped nails through the holes thus forming what Mrs. HistoryPhD says is a "Barbie table".

I drilled a hole through the center also, but I discarded the central leg as it made it more difficult to sit the "forest" over the top of a unit. At first, I just drilled holes in the four corners, but it wasn't enough "trunks" to resemble a lot of trees, so I added more. It's not possible to cut every nail the exact same length, but it sits quite stable, so it's not really an issue. Not all the legs are absolutely perpendicular, but then not all trees grow arrow-straight either. This is where it stopped being easy.

The next step was hot-gluing varied shades of foilage tufts to the top and edges of the "table":

On the bottom side, as an experiment, I used PVA to glue the tufts on. PVA doesn't leave a million, extremely annoying, little threads of glue hanging EVERYWHERE, however, it doesn't hold the tufts on worth a damn. Hot-glue, on the other hand, is a literal nightmare!! It holds the foilage on very sturdily, but there is honestly not one surface in our apartment that isn't now covered with gossamer glue threads. Mrs. History PhD has forbidden me to ever use a glue gun again!

So, lessons learned: 1) "Forests" need to be fairly large. This small one that I made as a test platform is a bit tight to fit over the top of a unit. 2) Use fewer "trunks" and spread them out farther from each other. If they're too close together, they look very good as a forest, but it makes it difficult to fit it over the top of a unit. 3) Use an adhesive other than PVA or hot glue (maybe latex "tacky" glue?) and use very small tufts for the forest's bottom side. In future, I may just use coarse flock on the bottom side. I think 3/4" nails are slightly too long scale-wise, but it makes it easier to sit the forest on top of things.

Not expensive to make and I think it looks fairly realistic and it's certainly functional. What's your solution to this issue?

More next time!