[Vis5d-users] Wrong upper boundary of Skew-T and Vertical Plot Display

Hi,

I use vis5d+-1.1 to display 3-d wind, potential temperature, and 
temperature fields  generated by a non-hydrostatic model (RAMS).
Typically the simulations extend to 30 km altitude and are displayed 
correctly  in the 3-d window.
The Skew-T and Vertical Plot Display however truncates the profiles at the 
50 hPa isobar. The wind vectors at the left side of the display and the 
height lables at the right side continue above this level, but the window 
is not large enough to show the top of these either. Manually enlarging the 
window with the mouse does not cure the problem. The number of vertical 
levels in the fields is 100.
Increasing the layer spacing and decreasing the number of vertical levels, 
but keeping the top level at 30 km does not cure the problem.

This problem was not present in older versions of vis5d.
Has this problem been solved in vis5d+-1.2.0 ?
If not, could you please tell me where to correct this problem in the 
source code.

Sincerely, Ib Steen

_________________________________
Ib Steen Mikkelsen
Middle Atmosphere Section
Research and Development Division
Danish Meteorological Institute
Lyngbyvej 100
DK-2100  Copenhagen
Denmark

Telephone: +45 39157413
Fax:       +45 39157460