[Vis5d-users] Not Enough Memory

Good Morning:

Running VIS5D5.1, HP9000/C110 HP-UX 10.20. Using MBS 32 in vis5d.h get
message at startup -- unable to allocate 26214400 bytes of memory. If use
MBS 16 runs but can not do isosurfaces or slices. If use -mbs 0 can do
slices but not isosurfaces. Have 128 MB on system. Just installed additional
memory now have 512 MB. Still have same problem with not enough memory. Do I
need to recompile VIS5D5.1 after additional memory installed? What should I
set MBS to? How do I get VIS5D to use the installed memory? Shared memory
facility maximum segment size problem?  Any help would be appreciated.

Thanks 


Greg

Gregory D. Salottolo
National Resource Specialist
Meteorology
National Transportation Safety Board
490 L'Enfant Plaza  East, SW
Washington D.C. 20594-0003
Work 202.314.6338
Fax 202.314.6339
e-mail sa...@nt...