[Vis5d-users] Re:

Try adding "-DLITTLE" to CFLAGS in your Makefile (a copy of
foo2_to_v5d.f.m).

Good luck,
Bill

"R.B.Oza" wrote:
> 
> Hello everybody !
> I am beginer in using vis5d.
> Based on the foo2_to_v5d.f file, I have made a conversion program in which
> innme file is used to initialize the required variables where as G array
> is populated through multiple files. This program I am running it on
> Dec-Alpha machine. The conversion program generates the required *.v5d
> file, however when I try to run v5dinfo or vis5d it gives the following
> message
>  Error: not a v5d file
>  Error: couldn't open *.v5d
> 
> In fact in conversion program, at number of places I have put print
> statement for success and failure (as it is indicated in original
> foo2_to_v5d.f file), and it is always successfull ! In Map Projection I
> have tried generic rectilinear (in which I suppose we have to give bounds
> of the 3D box in arbitrary unit and its increments) and stereographic map
> projection. Even after number of trials I could not get a v5d file which
> will not give the error message.
> 
> Infact in the same system, I am able visualize LAMPS.v5d data set, and it
> also works with v5dinfo.
> 
> Eagerly waiting for some responce....
> 
> Thanks a lot,
> 
> R.B.Oza
> Aerosol Monitoring and Simulation Section,
> Environmental Assessment Division,
> Bhabha Atomic Research Centre
> Trombay, Mumbai-400 085
> INDIA
> _______________________________
> E-mail: rb...@ma...
> phone : 5505050 Ext : 2200
> Fax : 91-22-5505151
> 
> Residence: 403, Nilgiri, Anushaktinagar, Mumbai-400 094. Phone:556 2742

-- 
----------------------------------------------------------
Bill Hibbard, SSEC, 1225 W. Dayton St., Madison, WI  53706
hi...@fa...  608-263-4427  fax: 608-263-6738
http://www.ssec.wisc.edu/~billh/vis.html