выход - с коммутатором 2. Выходы логических элементов И-ИЛИ 3 соединены с соответствующими входами выходного регистра 11.output - with switch 2. The outputs of the logical elements AND-OR 3 are connected to the corresponding inputs of the output register 11.
Устройство работает следующим образом.The device works as follows.
После набора на клавиатуре необходимой информации (служебного символа), на вход ГОИ подаетс сигнал запуска. Выходной импульс ГОИ 7 поступает на управл ющие входы элементов И-ИЛИ 3 и на элемент задержки 8. Задержанный на врем ввода в ЭВМ служебного символа, выходной импульс ГОИ 7 через элемент задержки 8 поступает на один из входов элемента И 9, второй вход которого соединен с блоком сопр жени 10. В случае разрешени ввода, на выходе элемента И 9 по вл етс импульс, устанавливаюп;ий триггер 5 в единичное состо ние. Триггер о разблокирует коммутатор 2 и одновременно выдает разрешающий сигнал на вход элемента И 4.After the necessary information (service character) is typed on the keyboard, a start signal is sent to the GOI input. The output impulse of GOI 7 goes to the control inputs of the AND-OR 3 elements and the delay element 8. Delayed by the introduction of a service symbol into the computer, the output impulse of the GOI 7 goes through a delay element 8 to one of the inputs of the And 9 element, the second input of which is connected with the interface unit 10. In the case of input resolution, the output of the element And 9 appears impulse, setting; trigger 5 into one state. A trigger unlocks switch 2 and at the same time generates an enable signal to the input of the AND 4 element.
Управл ющие сигналы с коммутатора 2 через элемент И 4 поступают на соответствующие входы элементов И-ИЛИ 3. Информаци от датчиков 1 через коммутатор 2 поступает на входы элементов И-ИЛИ 3 и далее на выходной регистр 11. По сигналу конца ввода из блока сопр жени 10 триггер 5 сбрасываетс и блокирует прохождение управл ющих сигналов коммутатора 2 через элемент И 4. При разрешении следующего ввода, которое поступает от ЭВМ в блок сопр жени 10, устройство готово к вводу следующей информации по сигналу от клавиатуры 6 по желанию оператора.The control signals from the switch 2 through the AND 4 element arrive at the corresponding inputs of the AND-OR 3 elements. Information from the sensors 1 through the switch 2 enters the inputs of the AND-OR 3 elements and further to the output register 11. The input end signal from the interface block 10, the trigger 5 is reset and blocks the passage of the control signals of the switch 2 through the element 4. At the resolution of the next input, which comes from the computer to the interface unit 10, the device is ready to enter the next information on the signal from the keyboard 6 at the request of the operator.
Устройство дает возможность оператору вмешиватьс в процесс ввода информации в режиме разделени времени. Возможность идентификации вводимой информации позвол ет формировать на магнитной ленте ЭВМ архив данных. Последнее особенно важно в медицине, когда обследуетс огромное количество людей и введенна информаци вл етс материалом дл клинических и научных исследований .The device allows the operator to intervene in the process of entering information in a time sharing mode. The ability to identify the information entered allows a data archive to be formed on a magnetic tape of a computer. The latter is especially important in medicine, when a huge number of people are examined and the information entered is material for clinical and scientific research.