Claims (1)
Способ управления процессом ультразвуковой липосакции, заключающийся в непрерывном контроле параметров ультразвуковой колебательной системы с различными по длине и назначению рабочими инструментами, при изменяющихся условиях введения УЗ колебаний и изменениях параметров обрабатываемых сред, получении контрольных данных и выработке управляющих сигналов на их основе, обеспечивающих изменение амплитуды электрического напряжения, прикладываемого к преобразователю колебательной системы, отличающийся тем, что в процессе проведения липосакции измеряют величину амплитуды тока, являющегося разностью между током, протекающим через пьезоэлектрические элементы преобразователя колебательной системы и реактивной емкостной составляющей этого тока, обусловленной собственной электрической емкостью пьезоэлектрических элементов, и величину амплитуды электрического напряжения, прикладываемого к электродам пьезоэлектрических элементов, по измеряемым амплитуде тока и амплитуде напряжения, определяют значения волнового сопротивления акустической нагрузки колебательной системы, каждое из полученных значений волнового сопротивления сравнивают с предыдущим, или принимают в качестве исходного значения при первом измерении, в случае, если полученное значение волнового сопротивления отличается от предыдущего - увеличивают или уменьшают амплитуду электрического напряжения, подаваемого от электронного генератора на преобразователь, изменение амплитуды питающего электрического напряжения, при измерении амплитуд тока и напряжения, осуществляют до тех пор, пока полученное значение волнового сопротивления и его предыдущее значение сравняются с заданной точностью.The method of controlling the process of ultrasonic liposuction, which consists in continuous monitoring of the parameters of the ultrasonic vibrating system with different lengths and purpose of the working tools, under changing conditions for the introduction of ultrasonic vibrations and changes in the parameters of the processed media, obtaining control data and generating control signals based on them, providing a change in the amplitude of the electric voltage applied to the converter of the oscillatory system, characterized in that in the process Sacraments measure the magnitude of the amplitude of the current, which is the difference between the current flowing through the piezoelectric elements of the transducer of the oscillatory system and the reactive capacitive component of this current, due to the intrinsic electric capacity of the piezoelectric elements, and the magnitude of the amplitude of the electrical voltage applied to the electrodes of the piezoelectric elements, according to the measured current amplitude and amplitude voltage, determine the value of the wave impedance of the acoustic load systems, each of the obtained values of the wave resistance is compared with the previous one, or taken as the initial value during the first measurement, if the obtained value of the wave resistance is different from the previous one, increase or decrease the amplitude of the electric voltage supplied from the electronic generator to the converter, change the amplitude supply voltage, when measuring the amplitudes of the current and voltage, carry out until the obtained value of the wave impedance and its previous value will be compared with the given accuracy.