Przedmiotem zgłoszenia jest profil ościeżnicy składający się z kształtownika zamkniętego (O), który charakteryzuje się tym, że kształtownik zamknięty (O), w przekroju poprzecznym ma kształt zbliżony do wielokąta, oraz wewnątrz kształtownika (O) są dwie równoległe przegrody, przegroda pierwsza (P1) i przegroda druga (P2), gdzie przegroda pierwsza (P1) oddziela komorę pierwszą (K1) od komory drugiej (K2) oraz styka się prostopadle z przegrodą wsporczą (7), oraz przy komorze pierwszej (K1) w dolnej prawej części są dwie zewnętrzne wnęki (4) prostopadłe względem siebie, oraz nad przegrodą wsporczą (7) jest równoległa ściana technologiczna (10), obie o grubości w przedziale od 4 mm do 8 mm, między którymi jest komora technologiczna (8) oraz do ściany technologicznej (10) dołączona jest przylga (6) z wpustem (1) oraz prostopadły ogranicznik (5), przy czym między przegrodą pierwszą (P1) i przegrodą drugą jest komora druga (K2), wewnątrz której są naprzeciwległe płaskowniki (3), prostopadłe do przegród oraz przegroda druga oddziela komorę drugą (K2) od komory trzeciej (K3), gdzie komora trzecia (K3) ma ścianę końcową poniżej przegrody wsporczej (7) oraz komora trzecia (K3) ma wypust (9), prostopadły do ściany komory trzeciej (K3), gdzie wypust (9) ma długość w przedziale do 13 mm oraz komora trzecia (K3) w dolnej lewej części ma dwie zewnętrzne wnęki (4), prostopadłe względem siebie oraz w komorze drugiej (K2) na złączeniu profilu z drugim profilem są dwa łączniki o szerokości odpowiadającej szerokości komory drugiej (K2), w której są umieszczone.The subject of the application is a frame profile consisting of a closed section (O), which is characterized in that the closed section (O) has a cross-sectional shape similar to a polygon, and inside the section (O) there are two parallel partitions, the first partition (P1 ) and the second partition (P2), where the first partition (P1) separates the first chamber (K1) from the second chamber (K2) and meets perpendicularly with the supporting partition (7), and at the first chamber (K1) in the lower right part there are two the outer cavities (4) perpendicular to each other, and above the support partition (7) there is a parallel technological wall (10), both with a thickness ranging from 4 mm to 8 mm, between which there is a technological chamber (8) and to the technological wall (10) ), a rebate (6) with a groove (1) and a perpendicular limiter (5) are attached, and between the first partition (P1) and the second partition there is a second chamber (K2), inside which there are opposite flat bars (3), perpendicular to partitions and the second partition separate the second chamber (K2) from the third chamber (K3), where the third chamber (K3) has an end wall below the supporting partition (7) and the third chamber (K3) has a projection (9) perpendicular to the wall of the third chamber ( K3), where the projection (9) has a length within the range of 13 mm and the third chamber (K3) in the lower left part has two external recesses (4) perpendicular to each other and in the second chamber (K2) at the joint between the profile and the second profile are two connectors with a width corresponding to the width of the second chamber (K2) in which they are placed.