ES1076558U - Dog excrement collector (Machine-translation by Google Translate, not legally binding) - Google Patents

Abstract

Dog excrement collector characterized by being made of a piece of cardboard or cardboard, called palette, flat, without bends, rectangular in shape, rigid in its longitudinal direction and with rounded corners. (Machine-translation by Google Translate, not legally binding)

Description

Excrement picker for dogs.

Mastery of the technique

Devices for urban cleaning.

       \ vskip1.000000 \ baselineskip
    

State of the art

For a few years, the municipalities have forced to dog owners to collect the droppings that their pets deposit on public roads and parks, and for this purpose various devices have been invented. The most useful is the bag of plastic and the "manual" collection of these excrements with the bag.

Various devices have been invented for separate your hand as much as possible from these droppings at the time of pick them up. These remote collection devices are usually plastic, are long, uncomfortable to wear, dirty once collected the droppings so you have to proceed to cleaning later etc ...

We have found one, which is the closest to Our solution, made of cardboard, but due to its dimensions it is necessary to carry it in a bag or purse; said cardboard has some bends and cuts to proceed to assembly, at the previous time to use, until you get a kind of cone with which Pick up the droppings. Excrements are collected with an edge of the cone and fingers are not protected from unwanted contact with the dejections and once this is done you have to close it by pushing, for this, with the hand the piece that was in contact with the these droppings. Once closed, the cone is introduced into the garbage container

Our solution does not need a bag to transport it, as it is carried in the back pocket of the pants; no It needs assembly before use, it is protected from possible contacts of the fingers with the excrement, it is discarded after use it and for its simplicity and size is cheaper than the previously exposed. Our utility model, which we present, It aims to meet the conditions of being simple, effective, clean, portable, disposable, biodegradable and especially cheaper than So far known.

       \ vskip1.000000 \ baselineskip
    

Description of the utility model

Our excrement collector consists of three parts:

The pallet, consisting of a piece of cardboard or cardboard, rectangular, without bends, and dimensions appropriate to be transported in the back pocket of a pants. Designated with the number 1 in Figures, 1, 2, 3, 4, 5, 6 and 7.

The finger guard 2, which is a piece rectangular paper glued on top of palette 1, intended to avoid contact between the thumb and the faeces. Figures, 1, 2, 3, 4, 5, 6 and 7.

The finger guard 3, is another piece of paper rectangular in shape at the bottom of palette 1, intended to avoid contact of the other fingers with the faeces. Figures, 1, 2, 3, 4, 5, 6 and 7.

The corners of the palette 1 can be angled straight or rounded for easy handling.

Protector 3 is usually a bit longer that protector 2, to facilitate the introduction of the fingers, pear can be the same length and not necessarily both should exceed the rear limit of the pallet.

Paper protectors 2 and 3 will be normally attached to palette 1, by glue but could be attached to it by any other method, such as sewn, stapled etc..

Protectors 2 and 3 may be constituted for a thin plastic sheet instead of paper.

Fig. 1 represents the elevation of the model of utility with protectors 1 and 2 in their initial position or of transport.

Fig. 2 corresponds to the collector elevation with open protectors, before hand insertion.

Fig. 3 is the pickup floor.

Fig. 4, is the left side view of the picker.

Fig. 5, represents the pickup powered by hand in the act of collecting canine excrements, 4, from A horizontal point of view.

Fig. 6 the same action in figure 5, from A vertical point of view.

Fig. 7 illustrates the end of collection in the that after introducing the excrement in a plastic bag, the collector is discarded introducing it in the bag, to subsequently be deposited the whole set, in the container of appropriate garbage.

       \ vskip1.000000 \ baselineskip
    

Advantages of the requested utility model

It is simpler than any other than let's meet

It is lighter than any other than let's meet

It is more portable to be able to carry one or several in the back pocket of the pants.

It is easier to handle.

It is cleaner by not having to clean it, nor approach stained pickup areas once collected faeces.

It is disposable.

It is biodegradable.

It is cheaper to be the simplest.

Claims (4)

1. Excrement collector for dogs characterized by being a piece of cardboard or cardboard, called a pallet, flat, without bends, rectangular, rigid in its longitudinal direction and with its rounded corners. 2. Excrement catcher for dogs according to the preceding claim, characterized by having a piece of paper or thin plastic, rectangular, of similar width that the pallet and attached, by a narrow transverse strip, to the back of the palette of the claim anterior and at the top of said pallet and that exceeds the length thereof. 3. Excrement catcher for dogs, according to previous claims, characterized by having a piece of paper or thin plastic, rectangular, of similar width that the palette of the first claim and attached, by a narrow transverse strip, to the back of the palette and its bottom. Said piece of paper exceeds the length of the pallet of the first claim and the length of the piece of paper of the second claim. 4. Excrement collector for dogs, according to previous claims characterized in that the pieces of paper of claims 2 and 3 can be of equal length and not exceed, one of them or both, the rear limit of the palette of claim 1 .