Phasenvergleichsschaltung zur Synchronisierung der Zeilenablenkung
in Fernsehempfängern Bei Femsehempfängem wird bekanntlich die Zeilenablenkschaltung
vom Sender synchronisiert. Ein hierzu verwendetes Mittel ist der Zeilendiskriminator.
Für ihn wurden zunächst Schaltungen benutzt, bei denen zwei Synchronisierzeichen
gleicher Größe und verschiedener Polarität benutzt werden. Zur Herstellung dieser
Impulse benötigt man einen Transformator oder eine Phasentrennröhre. Es gibt auch
Schaltungen, die mit einem Synchronisierimpuls auskommen, bei denen zwei Sägezahnspannungen
gleicher Größe und verschiedener Polarität vorliegen müssen. Für diese Sägezahnspannungen
benötigt man zwei symmetrische Wicklungen auf dem Zeilenausgangstransformator, die
bei einem Zeilenausgangstransformator aus Platzgründen nicht vorhanden sind.Phase comparison circuit for synchronizing the line deflection
in television receivers As is known, the line deflection circuit is used in television receivers
synchronized by the transmitter. One means used for this is the line discriminator.
For him, circuits were initially used in which two synchronization characters
of the same size and different polarity. To make this
Pulses you need a transformer or a phase separation tube. There are also
Circuits that get by with one synchronization pulse, in which two sawtooth voltages
must be of the same size and polarity. For these sawtooth voltages
you need two symmetrical windings on the line output transformer, the
are not available in a line output transformer for reasons of space.
Eine bekannte Schaltung, die diese Schwierigkeiten umgeht, ist in
Abb. 1 dargestellt. Sie benutzt nur einen Synchronisierimpuls und eine erdunsymmetrische
Vergleichsspannung, die durch zwei Widerstände aufgeteilt wird. Diese Schaltung
hat den Nachteil, daß die Vergleichssägezahnspannung über den zur Kopplung mit der
vor der Phasenvergleichsstufe liegenden Röhre verwendeten Kondensator auf die Anode
der Röhre gelangen kann, so daß andere Spannungen, die dort abgenommen werden,
z. B. die Bildsynchronisierimpulse, durch diese Rückwirkung beeinträchtigt werden.A known circuit that bypasses these difficulties is shown in FIG. 1. It only uses a synchronization pulse and an unbalanced reference voltage that is divided by two resistors. This circuit has the disadvantage that the comparison sawtooth voltage can reach the anode of the tube via the capacitor used for coupling with the tube located in front of the phase comparison stage. B. the image synchronization pulses are affected by this reaction.
Gemäß der Erfindung werden bei einer Phasenvergleichsschaltung zur
Synchronisierung der Zeilenablenkung in Fernsehempfängern mittels eines Diskriminators
mit zwei Dioden, denen die Synchronisierimpulse anodenseitig zugeführt werden und
deren Kathoden durch die Serienschaltung zweier Widerstände miteinander verbunden
sind, diese Widerstände R, und R 3 durch Kondensatoren C, und
C,
überbrückt, deren Verbindungspunkt geerdet und über einen Widerstand R4
mit den Anoden der beiden Dioden verbunden ist, wobei den Dioden Rücklaufimpulse
von der Wicklung S, des Zeilenausgangstransforinators zugeführt werden, und
zwischen der Kathode der Diode G, und dem Kondensator C 3 ein Kondensator
C4 eingeschaltet ist, und die Regelspannung vom Verbindungspunkt zwischen dem Kondensator
C 4 und der Diode G, abgenommen wird.According to the invention, in a phase comparison circuit for synchronizing the line deflection in television receivers by means of a discriminator with two diodes, to which the synchronizing pulses are fed on the anode side and whose cathodes are connected to one another by the series connection of two resistors, these resistors R, and R 3 by capacitors C, and C, whose connection point is grounded and connected to the anodes of the two diodes via a resistor R4, the diodes being supplied with flyback pulses from the winding S of the line output transformer, and a capacitor between the cathode of the diode G and the capacitor C 3 C4 is switched on, and the control voltage from the connection point between the capacitor C 4 and the diode G is taken.
Ein Ausführungsbeispiel der Schaltung ist in der Abb. 2 dargestellt.An exemplary embodiment of the circuit is shown in FIG.
Die Röhre Röl gibt positive Synchronisierimpulse ab. Sie kann beispielsweise
die zweite Röhre eines Doppelclippers sein und liefert außer den Zeilensynchronisierimpulsen
auch die Spannung für die Bildsynchronisation. über den Kondensator C, werden
die Synchronisierimpulse den Anoden der Dioden Gl und G2 des Diskriminators
zugeführt. Zur Herstellung der Vergleichssägezahnspannungen werden von der Spule
S, des Zeüenausgangstransformators Rücklaufirnpulse abgenommen. Da die Verbindung
zwischen den Kondensatoren C2 und C, geerdet ist, treten an den Punkten
Pl und P, Sägezahnspannungen mit entgegengesetzten Vorzeichen auf. Die Spannung
über C 3 ist relativ klein und das Ende der Wicklung praktisch geerdet. Dieses
ist notwendig, weil sonst wegen der hohen Spitzenspannungen der Impulse, die in
der Nähe der Transformatorwicklung S, liegen, kapazitiv auf die Wicklung
S, ein zusätzlicher Impuls übertragen wird, der die Symmetrie stören würde. Außerdem
kann man bei dieser Schaltung noch eine Impulsspannung von der WicklungS,
abnehmen, z. B. an einem Angriff eines als Potentiometer ausgebildeten Widerstandes
R.. Es liegt also über C2 und C 3 mit Bezug auf die PunktePl. P2 bzw.
PD P, eine Impulsspannung einer Polarität und eine Sägezahnspannung verschiedener
Polarität. Durch die Glieder R2, C2 und R 33 C, wird die Sägezahnspannung
nicht beeinflußt. Jedoch liegen die Punkte P, und P, gleichstrommäßig an Erde. Infolgedessen
ist auch die Regelspannung erdunsymmetrisch. Mittels des Gleichrichters
G, baut sich eine Gleichspannung auf, die aus einer überlagerung der zwischen
P#, und P:, stehenden Wechselspannungen entsteht.
Der Widerstand
R4 dient als Diodenableitwiderstand. Die zwischen den Punkten P 3 und P2
stehende Wechselspannung wird durch einen Gleich-. gleichgerichtet, und zwar
steht die Gleichrichter G,
spannung, da die Kapazität C4 vor P2 eingeschaltet
ist, zwischen den Punkten P', und P4, wobei P4 POS'-tiv gegenüber P, ist. Durch
die Wirkung des Gleichrichters G, liegt an der Diode G, gleichzeitig
eine negative Spannung. Somit steht an P4 letzten Endes eine Spannung, die nur den
Unterschied der beiden Spannungen zwischen P, und P, und zwischen P und P4 darstellt,
d. h. eine Steuerspannung, die je
nach Phasenlage von Synchronisierimpuls
und Vergleichssägezahn positiv oder negativ ist. Der Widerstand R- dient als Diodenableitwiderstand,
der Widerstand R und der Kondensator C, dienen als Sieb-6 mittel
. Die Regelspannung wird bei Rsp abgenom men. Die Schaltung ist rückwirkungsfrei,
da die Sägezahnspannungen an P, und P, infolge der Symmetrie der Schaltung an der
Anode von Rö, sich aufheben. Der Kondensator Ci kann infolgedessen eine Größe haben
(in der praktischen Ausführung 1 nF), die gewührleistet, daß während einer
Periode das Synchronisierzeichen nicht absinkt.The Röl tube emits positive synchronization pulses. It can, for example, be the second tube of a double clipper and, in addition to the line synchronization pulses, also supplies the voltage for the image synchronization. Via the capacitor C, the synchronization pulses are fed to the anodes of the diodes Gl and G2 of the discriminator. To produce the comparison sawtooth voltages, return impulses are taken from the coil S, of the signal output transformer. Since the connection between the capacitors C2 and C i is grounded, sawtooth voltages with opposite signs occur at the points P1 and P i. The voltage across C 3 is relatively small and the end of the winding is practically grounded. This is necessary because otherwise, because of the high peak voltages of the pulses, which are in the vicinity of the transformer winding S, an additional pulse would be capacitively transferred to the winding S, which would disturb the symmetry. In addition , you can still take a pulse voltage from the winding S, z. B. on an attack by a resistor R designed as a potentiometer. It is thus above C2 and C 3 with reference to the points P1. P2 and PD P, respectively, a pulse voltage of one polarity and a sawtooth voltage of different polarity. The sawtooth voltage is not influenced by the elements R2, C2 and R 33 C. However, points P, and P, are DC-connected to earth. As a result, the control voltage is also unbalanced to earth. By means of the rectifier G, a direct voltage is built up, which arises from a superposition of the alternating voltages between P #, and P :,. The resistor R4 serves as a diode bleeder resistor. The alternating voltage standing between the points P 3 and P2 is replaced by a direct voltage . rectified, namely the rectifier G, voltage, since the capacitance C4 is switched on before P2, between the points P ', and P4, where P4 is POS'-tive compared to P i. Due to the action of the rectifier G, there is a negative voltage across the diode G at the same time. Thus, in the end, there is a voltage at P4 which only represents the difference between the two voltages between P 1 and P 1 and between P and P 4, i. H. a control voltage that is positive or negative depending on the phase position of the synchronization pulse and comparison sawtooth. The resistor R- serves as a diode leakage resistor, the resistor R and the capacitor C, serve as a sieve-6 medium . The control voltage is accepted at Rsp. The circuit does not have any reaction, since the sawtooth voltages at P, and P, due to the symmetry of the circuit at the anode of Rö, cancel each other out. As a result, the capacitor Ci can have a size (in the practical embodiment 1 nF) which ensures that the synchronization symbol does not decrease during a period.