Workshop

The door decker finishing system is comprised of two steel plates with handles on each attached with brass eyelets. Each plate is securely screwed into the center of either end of a door with a #8 x 1 1/4 inch phillips wafer head screw (included with purchase) prior to paint or stain application One pair used on each door is the best method for the average height/weighted door. Once the door deckers are attached, painting can begin. Spray one side and then with one person on each end of the...

Drawers without pricey drawer slides! #workbench #diy #shorts #diywoodwo...

Yes, you can make cabinet-quality cuts with this much-maligned tool, by using these can't-miss tips.

Ripping thin strips with your tablesaw fence positioned close to the blade is a no-no. At the end of the cut, the strip trapped between the spinning blade and fence can become a dangerous projectile. To safely rip the strips, build the simple jig shown from 3⁄4" scrap. (For the #8 screws used to attach the cleat, drill countersunk 5⁄32

Modular Workbenches by Kevin G - Forum - Paoson Woodworking

I need to make this! learn how to build a dust collection cart for you shop vac and dust separator. #dustcollection #woodwork #woodworking #freeplans

Learn how to capture 99% of your table saw dust with just a shop vac or a small dust collector. Save money and shop space with this hack.

226K views · 3.2K reactions | A simple box of drawers for hardware storage. | I needed a quick and simple set of drawers for organizing nuts, bolts, screws, and nails. | By Big | Facebook

It’s easy to cut sheet goods down to size with this tilt-out panel cutting guide. Step-by-step instructions, exploded views, materials list, and more—these plans have everything you need to build your own Panel Cutting Guide. What you get (Downloadable PDFs): Standard Plan: * 8.5” x 11” PDF of 6 printable (digital) pages of step-by-step instructions * 30 full-color photos and illustrations * Retail sources for hardware and supplies What you get (Printed & Shipped): Standard...

Bruce Kieffer demonstrates the proper way to calibrate a table saw fence so you can make dead-on cuts when you use your table saw for woodworking projects.

226K views · 3.2K reactions | A simple box of drawers for hardware storage. | I needed a quick and simple set of drawers for organizing nuts, bolts, screws, and nails. | By Big | Facebook

Hi, I would like to make some simple shop storage. A plywood cabinet with drawers than run in a dado is a really appealing plan - simple, modular and...

Knape & Vogt 19 in. H x 14 in. W x 23 in. D Wooden 35 Qt. Undermount Double Soft-Close Pull Out Trash Can in Gray