## Version 0.1.10
- Reverted changes made in 0.1.9 to the behavior of the decoder under non
libtiff-compatibility mode. Trying to read the decoder with an empty output
buffer will at least inspect the next symbol and either error or indicate the
end-of-stream accordingly.
## Version 0.1.9 (yanked)
- Increased decoding throughput by 3—30% depending on CPU and data.
- Added `{encode,decode}::Configuration` as builder types for their respective
module. They can be cheaply cloned.
- Added `decode::Configuration::with_yield_on_full_buffer` to explicitly opt-in
to libtiff compatibility. The decoder will not read or interpret further
symbols of the decoding stream when the output buffer is full. This enables a
caller to stop fetching symbols and elide an end of stream marker based on
out-of-band length information. The decoder might otherwise error, trying to
interpret data that does not belong to the stream.
## Version 0.1.8
- Fixed incorrect state after `Decoder::reset`
- Added `Debug` to result types
## Version 0.1.7
- Implicit reset is now supported for decoding.
## Version 0.1.6
- Fixed an integer overflow and panic that could occur during decoding.
Decoding performance may degrade after long sequences without a reset code.
## Version 0.1.5
- Added `IntoVec` adapters that simplify in-memory de- and encoding. A further
'one-shot' interface is exposed in the `Decoder` and `Encoder` themselves
which makes the process a one liner in the simplest cases. Contrary to
`IntoStream`, these are available in all cases and do not require `std`.
## Version 0.1.4
- Added `IntoAsync` adapters for asynchronous de- and encoding. The interface
is implemented only in terms of `futures = 0.3` traits at the moment.
- Code sizes smaller than 2 are now allowed for decoding. Since they do not
roundtrip it is still an error to use them in the decoder but this avoids
accidental panicking, i.e. denial of service, in parsers.
## Version 0.1.3
- Fixes an issue in compression that caused some data to be lost around clear
codes. This could corrupt the data stream.
## Version 0.1.2
- Fixes incorrect compression after `Encoder::reset`.
## Version 0.1.1
- The `IntoStream` types now reuse their internal buffers.
- Added the methods `set_buffer`, `set_buffer_size` to `IntoStream` for both
the encoder and decoder, used to control the automatic allocation.
- Deprecated `IntoStream` in configurations without the `std` feature where the
type can't even be constructed.
## Version 0.1.0 – Aleph
- Initial major release
- Support gif and tiff code size changes
- Rough performance numbers:
On i5-4690, 8GiB DIMM DDR3 Synchronous 1600 MHz (0,6 ns)
~70MB/s encode, ~230MB/s decode